Additional Product Facts
The InnoviFlash Reinforced Perimeter Strip requires no fastening through the membrane, which eliminates the potential for leaks from fastener penetration, and requires no heat-welding. It is for use as a base tie-in at angle changes, at either the horizontal or vertical element, with IKO InnoviTPO induction-welded, fully adhered and mechanically attached roofing systems. InnoviFlash RPS reduces any membrane bridging and helps to extend the service life of the membrane. The InnoviFlash Reinforced Perimeter Strip is an important component in the successful installation of an IKO InnoviTPO commercial roofing system and can help qualify for an appropriate IKO Diamond Shield Limited Warranty.
Product Data Sheets
Find a Distributor
IKO distributors are located throughout North America. Offering a variety of products and accessories to cover board and insulation, IKO distributors have all the right IKO products to meet your commercial project needs. To find a qualified distributor in your area, please fill out the form below.
OR
*IKO does not bear any responsibility for the Distributors presented on this page. They are all independent distributors and due diligence should be taken by the consumer when entering into any agreements with those distributors who are listed here. By agreeing you absolve IKO of any involvement in transactions between yourself and the 3rd party distributors shown on this page.
Find a Contractor
A network of roofing contractors may be found installing IKO roof systems and products throughout Canada and the USA. To find a qualified contractor in your area, please fill out the form below.
OR
*IKO does not bear any responsibility for the Contractors presented on this page. They are all independent contractors and due diligence should be taken by the consumer when entering into any agreements with those contractors who are listed here. By agreeing you absolve IKO of any involvement in transactions between yourself and the 3rd party contractors shown on this page.
