CSA A123.21 Summary Reports
TPO T-Joint Patch being heat welded
TPO Reinforced Perimeter Strip (RPS)
white TPO membrane roll
insulation used in a fullky adhered TPO installation

Tested Roof Assemblies CSA A123.21

The NBCC has referenced CSA A123.21-14 since 2015 to determine the dynamic wind uplift resistance of a low slope membrane roofing systems. IKO Commercial roofing systems, tested in accordance with CSA A123.21, can be found on this page. For additional information on IKO’s CSA assembly listings please contact your local IKO Commercial representative.
PARS
Close group icon
      • IKO Commercial Single-ply CSA Roof Assemblies Summary Sheet
      • PARS020 | IKO Innovi Over MA Gypsum Cover Board - Partially Attached Roofing System (Canada)
      • PARS021 | IKO Innovi TPO Over MA CoverShield – Partially Attached Roofing System (Canada)
      • PARS022 | IKO Innovi TPO Over MA Thermal Barrier – Partially Attached Roofing System (Canada)
    • View All
MARS
Close group icon
      • IKO Commercial Single-ply CSA Roof Assemblies Summary Sheet
      • MARS006 | IKO Innovi TPO MA @ 6” o.c. (8 ft sheet width) (Canada)
      • MARS007 | IKO Innovi TPO MA @ 12” o.c. (8 ft sheet width) (Canada)
      • MARS008 | IKO Innovi TPO MA @ 18” o.c. (8 ft sheet width) (Canada)
      • MARS009 | IKO Innovi TPO MA @ 6” o.c. Optional VR (8 ft sheet width) (Canada)
    • View All
AARS
Close group icon
      • AARS025 | IKO Innovi TPO Fully Adhered Gypsum System
      • AARS026 | IKO Innovi TPO Over SA Vapor Retarder
      • IKO Commercial Single-ply CSA Roof Assemblies Summary Sheet
    • View All